Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » how to bleed brakes on a 2002 chevy avalanche
Viewing all articles
Browse latest Browse all 10

Buick Repair Brakes Instructions

0
0

Repairing Buick brakes entails restoring brake pedal strain. Low brake fluid level attributable to air getting trapped within the strains is the most typical drawback. For the reason that system shouldn’t be air-tight, it’s doable for air to make its manner into the traces. The result’s a “spongy” brake pedal. To restore the system, be sure the fluid level is appropriate and bleed the air out of the brake traces.

Buick Repair Brakes Instructions

1. Open the hood and fasten the ability bleeder to the brake grasp cylinder. Take away the brake grasp cylinder cap by pushing down on the cap and turning it counterclockwise. Screw the cap linked to the facility brake bleeder to the highest of the grasp cylinder reservoir. The facility bleeder has its personal reservoir tank with a hand pump on the highest of it and a hose that runs from the tank to the grasp cylinder.

2. Take away the cap on the facility brake bleeder reservoir tank and fill it with brake fluid. Then, tighten the cap again onto the bleeder reservoir.

3. Pump the deal with on the highest of the bleeder reservoir tank to construct up pressure within the reservoir tank.

4. Place the 10mm field finish wrench over the bleeder valve on the brake caliper. Begin with the suitable rear wheel (passenger side rear). You could have to achieve behind the wheel to entry the valve. The valve is on the underside of the brake caliper on most Buicks.

5. Place the 1/4-inch bleeder tubing over the top of the bleeder valve. Make certain it’s safe on the valve.

6. Place the opposite finish of the hose right into a container that got here together with your bleeder package.

7. Open the bleeder valve and permit the air within the strains to flee. Some brake fluid can even be expelled. That is OK.

8. Shut the valve as soon as the strain has been fully launched.

9. Pump the deal with on the highest of the facility bleeder once more to construct up stress. Then, repeat steps 7 and 8. Proceed this course of till the entire air is out of the strains at that wheel after which transfer to the left rear wheel (driver facet) and bleed that facet. After you’ve gotten accomplished the left rear, transfer to the suitable front (passenger front) and at last the left front (driver front).

10. Test the brake pedal pressure after you’ve bled all 4 wheels and have the grasp cylinder cap again onto the highest of the grasp cylinder. Make it possible for the brake fluid within the grasp cylinder is between the higher and lower marks on the reservoir tank. Pump the brake pedal. It ought to be agency and stable with little pedal travel.

Read more : How to Repair Buick Brakes


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images